Snmp-Server Community - Dell S6100 Configuration Manual

Version
7.5.1.0
unknown
Example
Dell#config!------command run on host connected to switch: --------------!
> snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected to Router2. This
is a port connected to
IF-MIB::ifAlias.134792448 = STRING:
!------command run on Dell Networkingswitch: --------------!
Dell#snmp ifmib ifalias long
!------command run on server connected to switch: --------------!
> snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected to Router2. This
is a port connected to Router2. This is a port connected to Router2. This is a
port connected to Router2. This is a port connected to Router2.
IF-MIB::ifAlias.134792448 = STRING:
Dell#config

snmp-server community

Configure a new community string access for SNMPv1 v2 and v3.
Syntax snmp-server community community-name {ro | rw} [ipv6 ipv6-access-list-name
[ipv6 ipv6-access-list-name | access-list-name | security-name name] |
security-name name [ipv6 ipv6-access-list-name | access-list-name | security-
name name] | access-list-name [ipv6 ipv6-access-list-name | access-list-name |
security-name name]]]
To remove access to a community, use the no snmp-server community community-string {ro |
rw} [security-name name [access-list-name | ipv6 access-list-name | access-
list-name ipv6 access-list-name]] command.
Parameters
community-name
ro
rw
ipv6 access-list-
name
security-name
name
access-list-name
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
1498 Simple Network Management Protocol (SNMP) and Syslog
Description
Introduced on the C-Series.
Introduced on the E-Series.
Enter a text string (up to 20 characters long) to act as a password for SNMP.
Enter the keyword ro to specify read-only permission.
Enter the keyword rw to specify read-write permission.
(Optional) Enter the keyword ipv6 then an IPv6 ACL name (a string up to 16 characters
long).
(Optional) Enter the keywords security-name then the security name as defined by
the community MIB.
(Optional) Enter a standard IPv4 access list name (a string up to 16 characters long).