:POWer:TRANsient:NEXT
Command Syntax
:POWer:TRANsient:NEXT
The :POWer:TRANsient:NEXT command goes to the next step of the
transient analysis.
This command is equivalent to pressing the Next softkey on the
oscilloscope front panel when prompted during the analysis.
See Also
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see
page
1138)
":POWer:TRANsient:APPLy"
":POWer:TRANsient:EXIT"
":POWer:TRANsient:IINitial"
":POWer:TRANsient:INEW"
on page 591
on page 592
on page 593
on page 594
24
:POWer Commands
595