Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 998

33
:WGEN Commands
Introduction to The :WGEN subsystem provides commands to select the waveform
:WGEN
generator function and parameters.
Commands
Reporting the Setup
Use :WGEN? to query setup information for the WGEN subsystem.
Return Format
The following is a sample response from the :WGEN? query. In this case,
the query was issued following the *RST command.
:WGEN:FUNC SIN;OUTP 0;FREQ +1.0000E+03;VOLT +500.0E-03;VOLT:OFFS
+0.0E+00;:WGEN:OUTP:LOAD ONEM
998 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide