Marker:yunits:use - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:MARKer:YUNits:USE

Command Syntax
:MARKer:YUNits:USE
When PERCent is selected for :MARKer:YUNits, the :MARKer:YUNits:USE
command sets the current Y1 location as 0 percent and the current Y2
location as 100 percent.
Once the 0 and 100 percent locations are set, inputs to and outputs from
the :MARKer:Y1Position, :MARKer:Y2Position, and :MARKer:YDELta
commands/queries are relative to the set locations.
See Also
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
"Introduction to :MARKer Commands"
":MARKer:YUNits" on page 392
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MEASure:SOURce"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta" on page 391
on page 380
on page 383
on page 385
on page 444
on page 389
on page 390
19
:MARKer Commands
393