:WGEN:MODulation:FUNCtion
Command Syntax
:WGEN:MODulation:FUNCtion <shape>
<shape> ::= {SINusoid | SQUare| RAMP}
The :WGEN:MODulation:FUNCtion command specifies the shape of the
modulating signal.
When the RAMP shape is selected, you can specify the amount of time per
cycle that the ramp waveform is rising with the
:WGEN:MODulation:FUNCtion:RAMP:SYMMetry command.
This command applies to AM and FM modulation. (The FSK modulation
signal is a square wave shape.)
Query Syntax
:WGEN:MODulation:FUNCtion?
The :WGEN:MODulation:FUNCtion? query returns the specified modulating
signal shape.
Return Format
<shape><NL>
<shape> ::= {SIN | SQU| RAMP}
See Also
•
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see
page
1138)
":WGEN:MODulation:AM:DEPTh"
":WGEN:MODulation:AM:FREQuency"
":WGEN:MODulation:FM:DEViation"
":WGEN:MODulation:FM:FREQuency"
":WGEN:MODulation:FSKey:FREQuency"
":WGEN:MODulation:FSKey:RATE"
":WGEN:MODulation:FUNCtion:RAMP:SYMMetry"
":WGEN:MODulation:STATe"
":WGEN:MODulation:TYPE"
on page 1013
on page 1014
on page 1015
on page 1016
on page 1017
on page 1018
on page 1022
on page 1023
:WGEN Commands
on page 1020
33
1019