Mtest:{Start | Stop} - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

35
Obsolete and Discontinued Commands

:MTESt:{STARt | STOP}

Command Syntax
:MTESt:{STARt | STOP}
The :MTESt:{STARt | STOP} command starts or stops the acquisition
system.
The :MTESt:STARt and :MTESt:STOP commands are obsolete and are provided for
N O T E
backward compatibility to previous oscilloscopes. Use the :RUN command (see
and :STOP command (see
See Also •
1086
(see page 1138)
page
"Introduction to :MTESt Commands"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
223) instead.
on page 491
page 219)