Measure:vstop - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:MEASure:VSTOp

Command Syntax
:MEASure:VSTOp <vstop_argument>
<vstop_argument> ::= value for Y2 cursor
The :MEASure:VSTOp command moves the vertical marker 2 (Y2 cursor) to
the specified value corresponding to the selected source. The source can
be selected by the MARKer:X2Y2source command.
The short form of this command, VSTO, does not follow the defined Long Form to Short
N O T E
Form Truncation Rules (see
both VSTArt and VSTOp, so sending VST for the VSTOp command produces an error.
The :MEASure:VSTOp command is an obsolete command provided for compatibility to
N O T E
previous oscilloscopes. Use the :MARKer:Y2Position command (see
Query Syntax
:MEASure:VSTOp?
The :MEASure:VSTOp? query returns the current value of the Y2 cursor.
Return Format
<value><NL>
<value> ::= value of the Y2 cursor in NR3 format
See Also
•
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
"Introduction to :MARKer Commands"
"Introduction to :MEASure Commands"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta" on page 391
":MARKer:X2Y2source"
":MEASure:SOURce"
":MEASure:TDELta" on page 1068
":MEASure:TSTArt" on page 1072
Obsolete and Discontinued Commands
page 1140). The normal short form, VST, would be the same for
on page 380
on page 406
on page 389
on page 390
on page 385
on page 444
35
page 390) instead.
1079