Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 406

20
:MEASure Commands
Table 92 :MEASure Commands Summary (continued)
Command
:MEASure:VTOP
[<source>] (see
page 465)
:MEASure:WINDow
<type> (see page
:MEASure:XMAX
[<source>] (see
page 467)
:MEASure:XMIN
[<source>] (see
page 468)
Introduction to
The commands in the MEASure subsystem are used to make parametric
:MEASure
measurements on displayed waveforms.
Commands
Measurement Setup
To make a measurement, the portion of the waveform required for that
measurement must be displayed on the oscilloscope screen.
Measurement Type
period, duty cycle, or frequency
pulse width
rise time
fall time
Measurement Error
406
Query
:MEASure:VTOP?
[<source>] (see
page 465)
:MEASure:WINDow? (see
466) page 466)
:MEASure:XMAX?
[<source>] (see
page 467)
:MEASure:XMIN?
[<source>] (see
page 468)
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
Options and Query Returns
<source> ::= {CHANnel<n> |
FUNCtion | MATH | WMEMory<r>}
<n> ::= 1 to (# analog channels)
in NR1 format
<r> ::= 1-2 in NR1 format
<return_value> ::= voltage at the
top of the waveform in NR3 format
<type> ::= {MAIN | ZOOM | AUTO}
<source> ::= {CHANnel<n> |
FUNCtion | MATH | WMEMory<r>}
<n> ::= 1 to (# analog channels)
in NR1 format
<r> ::= 1-2 in NR1 format
<return_value> ::= horizontal
value of the maximum in NR3
format
<source> ::= {CHANnel<n> |
FUNCtion | MATH | WMEMory<r>}
<n> ::= 1 to (# analog channels)
in NR1 format
<r> ::= 1-2 in NR1 format
<return_value> ::= horizontal
value of the maximum in NR3
format
Portion of waveform that must be displayed
at least one complete cycle
the entire pulse
rising edge, top and bottom of pulse
falling edge, top and bottom of pulse