Sbus<N>:Iic:asize - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

27
:SBUS<n> Commands
:SBUS<n>:IIC:ASIZe
Command Syntax
:SBUS<n>:IIC:ASIZe <size>
<size> ::= {BIT7 | BIT8}
The :SBUS<n>:IIC:ASIZe command determines whether the Read/Write bit
is included as the LSB in the display of the IIC address field of the
decode bus.
Query Syntax
:SBUS<n>:IIC:ASIZe?
The :SBUS<n>:IIC:ASIZe? query returns the current IIC address width
setting.
Return Format
<mode><NL>
<mode> ::= {BIT7 | BIT8}
Errors
•
See Also •
•
708
(see page 1138)
"- 241, Hardware missing"
"Introduction to :SBUS<n> Commands"
":SBUS<n>:IIC Commands"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 1099
on page 629
on page 707