Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 664

27
:SBUS<n> Commands
CAN Id specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:ID
and:SBUS<n>:CAN:TRIGger:PATTern:ID:MODE commands.
CAN Data specification is set by the :SBUS<n>:CAN:TRIGger:PATTern:DATA
command.
CAN Data Length Code is set by the
:SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth command.
Query Syntax
:SBUS<n>:CAN:TRIGger?
The :SBUS<n>:CAN:TRIGger? query returns the current CAN trigger on
condition.
Return Format
<condition><NL>
<condition> ::= {SOF | DATA | ERR | IDD | IDE | IDR | ALL | OVER | ACK}
Errors
•
See Also
•
•
•
•
•
•
•
•
664
"- 241, Hardware missing"
"Introduction to :SBUS<n> Commands"
":SBUS<n>:MODE" on page 633
":SBUS<n>:CAN:TRIGger:PATTern:DATA"
":SBUS<n>:CAN:TRIGger:PATTern:DATA:LENGth"
":SBUS<n>:CAN:TRIGger:PATTern:ID"
":SBUS<n>:CAN:TRIGger:PATTern:ID:MODE"
":SBUS<n>:CAN:SIGNal:DEFinition"
":SBUS<n>:CAN:SOURce"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 1099
on page 629
on page 665
on page 667
on page 668
on page 661
on page 662
on page 666