Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 221

:SINGle
Command Syntax
:SINGle
The :SINGle command causes the instrument to acquire a single trigger of
data. This is the same as pressing the Single key on the front panel.
See Also •
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
"Introduction to Root (:) Commands"
":RUN" on page 219
":STOP" on page 223
Root (:) Commands
on page 190
6
221