Search:edge:slope - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

28
:SEARch Commands

:SEARch:EDGE:SLOPe

(see page 1138)
Command Syntax
:SEARch:EDGE:SLOPe <slope>
<slope> ::= {NEGative | POSitive | EITHer}
The :SEARch:EDGE:SLOPe command specifies the slope of the edge for the
search.
Query Syntax
:SEARch:EDGE:SLOPe?
The :SEARch:EDGE:SLOPe? query returns the current slope setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS | EITH}
See Also • Chapter 28, ":SEARch Commands," starting on page 777
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 783