Measure:dual:vbase - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:MEASure:DUAL:VBASe

Overview
This measurement is available with the N2820A high sensitivity current
probe when both the Primary and Secondary probe cables are used. This
measurement joins the Zoom In waveform data below the probe's clamp
level with Zoom Out waveform data above the probe's clamp level to create
the waveform on which the measurement is made.
Command Syntax
:MEASure:DUAL:VBASe [<source1>][,<source2>]
<source1>,<source2> ::= CHANnel<n> with N2820A probe connected
<n> ::= 1 to (# analog channels) in NR1 format
The :MEASure:DUAL:VBASe command installs a screen measurement and
starts a waveform base value measurement.
If the optional source parameter(s) are specified, the currently specified
source(s) are modified.
Query Syntax
:MEASure:DUAL:VBASe? [<source1>][,<source2>]
The :MEASure:DUAL:VBASe? query returns the vertical value at the base
of the waveform. The base value of a pulse is normally not the same as
the minimum value.
Return Format
<base_voltage><NL>
<base_voltage> ::= value at the base of the selected waveform in
See Also •
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
NR3 format
":MEASure:DUAL:CHARge"
":MEASure:DUAL:VAMPlitude"
":MEASure:DUAL:VAVerage"
":MEASure:DUAL:VPP"
":MEASure:DUAL:VRMS"
"Introduction to :MEASure Commands"
":MEASure:SOURce"
":MEASure:VTOP" on page 465
":MEASure:VMIN" on page 460
on page 418
on page 419
on page 420
on page 422
on page 423
on page 406
on page 444
20
:MEASure Commands
421