Wgen:modulation:am:depth - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:WGEN:MODulation:AM:DEPTh

Command Syntax
:WGEN:MODulation:AM:DEPTh <percent>
<percent> ::= AM depth percentage from 0% to 100% in NR1 format
The :WGEN:MODulation:AM:DEPTh command specifies the amount of
amplitude modulation.
AM Depth refers to the portion of the amplitude range that will be used
by the modulation. For example, a depth setting of 80% causes the output
amplitude to vary from 10% to 90% (90% – 10% = 80%) of the original
amplitude as the modulating signal goes from its minimum to maximum
amplitude.
Query Syntax
:WGEN:MODulation:AM:DEPTh?
The :WGEN:MODulation:AM:DEPTh? query returns the AM depth
percentage setting.
Return Format
<percent><NL>
<percent> ::= AM depth percentage from 0% to 100% in NR1 format
See Also •
•
•
•
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
":WGEN:MODulation:AM:FREQuency"
":WGEN:MODulation:FM:DEViation"
":WGEN:MODulation:FM:FREQuency"
":WGEN:MODulation:FSKey:FREQuency"
":WGEN:MODulation:FSKey:RATE"
":WGEN:MODulation:FUNCtion"
":WGEN:MODulation:FUNCtion:RAMP:SYMMetry"
":WGEN:MODulation:STATe"
":WGEN:MODulation:TYPE"
on page 1014
on page 1015
on page 1016
on page 1017
on page 1018
on page 1019
on page 1022
on page 1023
:WGEN Commands
on page 1020
33
1013