Sbus<N>:Lin:signal:definition - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:SBUS<n>:LIN:SIGNal:DEFinition
Command Syntax
:SBUS<n>:LIN:SIGNal:DEFinition <value>
<value> ::= {LIN | RX | TX}
The :SBUS<n>:LIN:SIGNal:DEFinition command sets the LIN signal type.
These signals can be set to:
Dominant low signals:
• LIN — the actual LIN single- end bus signal line.
• RX — the Receive signal from the LIN bus transceiver.
• TX — the Transmit signal to the LIN bus transceiver.
This command is available, but the only legal value is LIN.
N O T E
Query Syntax
:SBUS<n>:LIN:SIGNal:DEFinition?
The :SBUS<n>:LIN:SIGNal:DEFinition? query returns the current LIN signal
type.
Return Format
<value><NL>
<value> ::= LIN
See Also •
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 886
":SBUS<n>:LIN:SIGNal:BAUDrate"
":SBUS<n>:LIN:SOURce"
Obsolete and Discontinued Commands
on page 877
on page 721
on page 722
35
1091