Power:transient:exit - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

24
:POWer Commands

:POWer:TRANsient:EXIT

Command Syntax
:POWer:TRANsient:EXIT
The :POWer:TRANsient:EXIT command exits (stops) the transient analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope
front panel during the analysis.
See Also •
•
•
•
592
(see page 1138)
":POWer:TRANsient:APPLy"
":POWer:TRANsient:IINitial"
":POWer:TRANsient:INEW"
":POWer:TRANsient:NEXT"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 591
on page 593
on page 594
on page 595