Power:onoff:exit - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

24
:POWer Commands

:POWer:ONOFf:EXIT

Command Syntax
:POWer:ONOFf:EXIT
The :POWer:ONOFf:EXIT command exits (stops) the turn on time/turn off
time analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope
front panel during the analysis.
See Also
•
•
•
554
(see page 1138)
":POWer:ONOFf:APPLy"
":POWer:ONOFf:NEXT"
":POWer:ONOFf:TEST"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 553
on page 555
on page 556