Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 1105

Agilent InfiniiVision 3000 X-Series Oscilloscopes
Programmer's Guide
37
Status Reporting
Status Reporting Data Structures
Status Byte Register (STB)
Service Request Enable Register (SRE)
Trigger Event Register (TER)
Output Queue
Message Queue
(Standard) Event Status Register (ESR)
(Standard) Event Status Enable Register (ESE)
Error Queue
Operation Status Event Register (:OPERegister[:EVENt])
Operation Status Condition Register (:OPERegister:CONDition)
Arm Event Register (AER)
Overload Event Register (:OVLRegister)
Mask Test Event Event Register (:MTERegister[:EVENt])
Power Event Event Register (:PWRRegister[:EVENt])
Clearing Registers and Queues
Status Reporting Decision Chart
IEEE 488.2 defines data structures, commands, and common bit
definitions for status reporting (for example, the Status Byte Register and
the Standard Event Status Register). There are also instrument- defined
structures and bits (for example, the Operation Status Event Register and
the Overload Event Register).
An overview of the oscilloscope's status reporting structure is shown in
the following block diagram. The status reporting structure allows
monitoring specified events in the oscilloscope. The ability to monitor and
report these events allows determination of such things as the status of an
operation, the availability and reliability of the measured data, and more.
1107
1109
1112
1113
1114
1117
1120
1124
1125
s1
1111
1115
1116
1118
1119
1121
1122
1123
1105