Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 216

6
Root (:) Commands
:PWRenable (Power Event Enable Register)
Command Syntax
:PWRenable <mask>
<mask> ::= 16-bit integer
The :PWRenable command sets a mask in the Power Event Enable register.
Set any of the following bits to "1" to enable bit 7 in the Operation Status
Condition Register and potentially cause an SRQ (Service Request)
interrupt to be generated.
Table 77 Power Event Enable Register (PWRenable)
Bit
15-3
2
1
0
Query Syntax
:PWRenable?
The :PWRenable? query returns the current value contained in the Power
Event Enable register as an integer number.
Return Format
<value><NL>
<value> ::= integer in NR1 format.
See Also
•
•
•
•
•
•
216
(see page 1138)
Name Description
--- ---
Deskew Deskew Complete
Apply Apply Complete
Setup Setup Complete
"Introduction to Root (:) Commands"
":AER (Arm Event Register)"
":CHANnel<n>:PROTection"
":OPERegister[:EVENt] (Operation Status Event Register)"
":OVLenable (Overload Event Enable Register)"
":OVLRegister (Overload Event Register)"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
When Set (1 = High = True), Enables:
(Not used.)
Power analysis deskew is complete.
Power analysis apply feature is complete.
Power analysis auto setup feature is complete.
on page 190
on page 192
on page 276
on page 213
on page 209
on page 211