Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 198

6
Root (:) Commands
:BLANk
Command Syntax
:BLANk [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH | SBUS{1 | 2} | WMEMory<r>}
<source> ::= {CHANnel<n> | DIGital<d> | POD{1 | 2}
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
<r> ::= 1 to (# ref waveforms) in NR1 format
The :BLANk command turns off (stops displaying) the specified channel,
digital pod, math function, or serial decode bus. The :BLANk command
with no parameter turns off all sources.
To turn on (start displaying) a channel, etc., use the :VIEW command. The DISPlay
N O T E
commands, :CHANnel<n>:DISPlay, :FUNCtion:DISPlay, :POD<n>:DISPlay,
:DIGital<n>:DISPlay, :SBUS<n>:DISPlay, or :WMEMory<r>:DISPlay, are the preferred
method to turn on/off a channel, etc.
MATH is an alias for FUNCtion.
N O T E
See Also
•
•
•
•
•
•
•
•
•
Example Code •
198
(see page 1138)
for the DSO models
| BUS{1 | 2} | FUNCtion | MATH | SBUS{1 | 2} | WMEMory<r>}
for the MSO models
"Introduction to Root (:) Commands"
":DISPlay:CLEar" on page 303
":CHANnel<n>:DISPlay"
":DIGital<d>:DISPlay"
":FUNCtion:DISPlay"
":POD<n>:DISPlay" on page 525
":WMEMory<r>:DISPlay"
":STATus" on page 222
":VIEW" on page 225
"Example Code" on page 225
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 190
on page 266
on page 291
on page 333
on page 1036