Measure:upper - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

35
Obsolete and Discontinued Commands

:MEASure:UPPer

Command Syntax
:MEASure:UPPer <value>
The :MEASure:UPPer command sets the upper measurement threshold
value. This value and the LOWer value represent absolute values when the
thresholds are ABSolute and percentage when the thresholds are PERCent
as defined by the :MEASure:DEFine THResholds command.
The :MEASure:UPPer command is obsolete and is provided for backward compatibility to
N O T E
previous oscilloscopes. Use the :MEASure:DEFine THResholds command (see
instead.
Query Syntax
:MEASure:UPPer?
The :MEASure:UPPer? query returns the current upper threshold level.
Return Format
<value><NL>
<value> ::= the user-defined upper threshold in NR3 format
See Also •
•
•
1076
(see page 1138)
"Introduction to :MEASure Commands"
":MEASure:LOWer" on page 1066
":MEASure:THResholds"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 406
on page 1069
page 413)