Marker:xunits:use - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

19
:MARKer Commands

:MARKer:XUNits:USE

Command Syntax
:MARKer:XUNits:USE
When DEGRees is selected for :MARKer:XUNits, the :MARKer:XUNits:USE
command sets the current X1 location as 0 degrees and the current X2
location as 360 degrees.
When PERCent is selected for :MARKer:XUNits, the :MARKer:XUNits:USE
command sets the current X1 location as 0 percent and the current X2
location as 100 percent.
Once the 0 and 360 degree or 0 and 100 percent locations are set, inputs
to and outputs from the :MARKer:X1Position, :MARKer:X2Position, and
:MARKer:XDELta commands/queries are relative to the set locations.
See Also
•
•
•
•
•
•
•
•
388
(see page 1138)
"Introduction to :MARKer Commands"
":MARKer:XUNits" on page 387
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MEASure:SOURce"
":MARKer:X1Position"
":MARKer:X2Position"
":MARKer:XDELta" on page 386
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 380
on page 383
on page 385
on page 444
on page 382
on page 384