Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 205

:OPEE (Operation Status Enable Register)
Command Syntax
:OPEE <mask>
<mask> ::= 15-bit integer
The :OPEE command sets a mask in the Operation Status Enable register.
Set any of the following bits to "1" to enable bit 7 in the Status Byte
Register and potentially cause an SRQ (Service Request interrupt to be
generated.
OR
To OPER bit in
Status Byte
Register
Table 72 Operation Status Enable Register (OPEE)
Bit
14-12
11
10
9
8
7
6
5
4
3
2-0
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
From Overload From Mask Test From Power
Event Registers Event Registers Event Registers
PWR
OVLR MTE
11 9
OVLR MTE PWR
14 13 12 11 10 9 8
+
Name Description
--- ---
OVLR Overload
--- ---
MTE Mask Test Event
--- ---
PWR Power Event
--- ---
Wait Wait Trig
Trig
--- ---
Run Running
--- ---
Arm
AER?
Reg
Run bit set if oscilloscope not stopped
Wait
:OPEReration:CONDition?
Run
Trig
Operation Status Condition Register
7 5 3
Wait :OPERation[:EVENt]?
Run
Trig
Operation Status Event Register
7 6 5 4 3 2 1 0
:OPEE
:OPEE?
Operation Status Enable
(Mask) Register
When Set (1 = High = True), Enables:
(Not used.)
Event when 50 input overload occurs.
(Not used.)
Event when mask test event occurs.
(Not used.)
A power measurements application event has
occurred.
(Not used.)
Event when the trigger is armed.
(Not used.)
Event when the oscilloscope is running (not
stopped).
(Not used.)
6
Root (:) Commands
205