Marker:xdelta - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

19
:MARKer Commands

:MARKer:XDELta

Query Syntax
:MARKer:XDELta?
The MARKer:XDELta? query returns the value difference between the
current X1 and X2 cursor positions.
Xdelta = (Value at X2 cursor) - (Value at X1 cursor)
X cursor units are set by the :MARKer:XUNits command.
If the front-panel cursors are off, the marker position values are not defined. Make sure to
N O T E
set :MARKer:MODE to MANual or WAVeform to put the cursors in the front-panel Normal
mode.
Return Format
<value><NL>
<value> ::= difference value in NR3 format.
See Also
•
•
•
•
•
•
•
386
(see page 1138)
"Introduction to :MARKer Commands"
":MARKer:MODE" on page 381
":MARKer:X1Position"
":MARKer:X2Position"
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MARKer:XUNits" on page 387
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 380
on page 382
on page 384
on page 383
on page 385