Ssh Client Configuration Example; When Using Password Authentication - 3Com MSR 50 Series Configuration Manual

1940 C 102: SSH2.0 C
HAPTER
SSH Client
Configuration
Example
When Using Password
Authentication
ONFIGURATION
Figure 569 SSH client interface
Network requirements
As shown in Figure 570, Router A (the SSH client) needs to log in to Router B (the
SSH server) through the SSH protocol. The username of the SSH client is client001
and the password is aabbcc. Password authentication is required.
Network diagram
Figure 570 Network diagram for SSH client configuration (using password
authentication)
SSH server
Eth1 /1
10 .165 .87.136/24
Router B
Configuration procedure
1 Configure the SSH server
# Create RSA and DSA key pairs and enable the SSH server.
<RouterB> system-view
[RouterB] public-key local create rsa
[RouterB] public-key local create dsa
[RouterB] ssh server enable
# Configure the IP address of interface Ethernet 1/1, which the SSH client will use
as the destination for SSH connection.
SSH client
Eth1/1
10.165 .87 .137 /24
Router A