3Com MSR 50 Series Configuration Manual page 2402

2402 C 138: V FR C
HAPTER O ONFIGURATION
# Configure the fragment size of data packets in the case that the voice function is
enabled.
[RouterA-fr-class-vofr] fragment 100 voice-level
[RouterA-fr-class-vofr] quit
# Enter interface Serial 1/0 view and configure the encapsulation format and the IP
address.
[RouterA] interface serial 1/0
[RouterA-Serial1/0] link-protocol fr ietf
[RouterA-Serial1/0] ip address 1.1.1.1 255.255.255.0
# Configure a frame relay address mapping and enable traffic shaping.
[RouterA-Serial1/0] fr map ip 2.2.2.2 100
[RouterA-Serial1/0] fr traffic-shaping
# Configure a frame relay DLCI and set the frame relay class to "VoFR".
[RouterA-Serial1/0] fr dlci 100
[RouterA-fr-dlci-Serial1/0-100] fr-class vofr
# Specify the call control protocol to be used by DLCI 100 as Huawei-compatible
(DTE).
[RouterA-fr-dlci-Serial1/0-100] vofr huawei-compatible dte
[RouterA-fr-dlci-Serial1/0-100] quit
[RouterA-Serial1/0] quit
# Configure the VoFR entity (07552001).
[RouterA] voice-setup
[RouterA-voice] dial-program
[RouterA-voice-dial] entity 0755 vofr
[RouterA-voice-dial-entity755] match-template 07552001
[RouterA-voice-dial-entity755] address vofr-dynamic serial 1/0 100
[RouterA-voice-dial-entity755] quit
# Configure the local POTS entity (0101001).
[RouterA-voice-dial] entity 1001 pots
[RouterA-voice-dial-entity1001] match-template 0101001
[RouterA-voice-dial-entity1001] line 2/0
2 Configure Router B.
# Create a new frame relay class "VoFR".
<RouterB> system-view
[RouterB] fr class vofr
# Configure the voice bandwidth.
[RouterB-fr-class-vofr] voice bandwidth 32000 reserved
# Configure the fragment size of data packets in the case that the voice function is
disabled.