Configuring Hwtacacs; Creating A Hwtacacs Scheme; Specifying The Hwtacacs Authentication Servers; Specifying The Hwtacacs Authorization Servers - 3Com MSR 50 Series Configuration Manual

Configuring
HWTACACS
Creating a HWTACACS
scheme
Specifying the
HWTACACS
Authentication Servers
Specifying the
HWTACACS
Authorization Servers
To do...
Enter system view
Enable the listening port of
the RADIUS client
The HWTACACS protocol is configured on a per scheme basis. Before performing
other HWTACACS configurations, follow these steps to create a HWTACACS
scheme and enter HWTACACS scheme view:
To do...
Enter system view
Create a HWTACACS scheme
and enter HWTACACS
scheme view
n
Up to 16 local HWTACACS schemes can be configured.
■
A scheme can be deleted only when it is not referenced.
■
Follow these steps to specify the HWTACACS authentication servers:
To do...
Enter system view
Create a HWTACACS scheme
and enter HWTACACS
scheme view
Configure the IP address and
port of the primary
HWTACACS authentication
server
Configure the IP address and
port of the secondary
HWTACACS authentication
server
n
The IP addresses of the primary and secondary authentication servers cannot
■
be the same. Otherwise, the configuration fails.
You can remove an authentication server only when no active TCP connection
■
for sending authentication packets is using it.
Follow these steps to specify the HWTACACS authorization servers:
To do...
Enter system view
Use the command...
system-view
radius client enable
Use the command...
system-view
hwtacacs scheme
hwtacacs-scheme-name
Use the command...
system-view
hwtacacs scheme
hwtacacs-scheme-name
primary authentication
ip-address [ port-number ]
secondary authentication
ip-address [ port-number ]
Use the command...
system-view

Configuring HWTACACS

Remarks
-
Optional
Enabled by default
Remarks
-
Required
By default, no HWTACACS
scheme is created.
Remarks
-
Required
By default, no HWTACACS
scheme is created.
Required
The defaults are as follows:
0.0.0.0 for the IP address, and
49 for the TCP port.
Required
The defaults are as follows:
0.0.0.0 for the IP address, and
49 for the TCP port.
Remarks
-
1777