Configuring Registration Password - 3Com MSR 50 Series Configuration Manual

Configuring Registration
Password
Configuration procedure
Follow these steps to configure basic H.323 gateway functions:
To do...
Enter system view
Enter voice view
Configure an H.323
descriptor
Enter gateway view
Assign an area ID to the
H.323 gateway
Bind a source IP address,
normally the IP address of a
loopback interface, with the
H.323 gateway
Configure a gateway alias
Configure a primary
gatekeeper
Configure a secondary
gatekeeper
Activate the gatekeeper client
function to register with the
gatekeeper
n
For more information about POTS and VoIP entities, refer to
■
Entity" on page 2266
Before you can configure a secondary gatekeeper, you must first configure a
■
primary gatekeeper with the gk-id command.
You can use the ras-on command to register with the gatekeeper only after
■
you complete all required basic voice gateway configurations.
You may configure the gateway to send a password with the RPQ message sent
for registration with the gatekeeper. When the gatekeeper receives this request, it
compares the password with the one configured on it for the gateway. Only when
they are the same will the gatekeeper accept the request and return an RCF.
After the GK Client (router) is configured with the register password, the password
is carried during the whole register process.
Use the command...
system-view
voice-setup
voip h323-descriptor
descriptor
gk-client
area-id string
gw-address ip-address
gw-id namestring
gk-id gk-name gk-addr
gk-ipaddress [ ras-port ]
gk-2nd-id gk-name
gk-addr gk-ipaddress
[ ras-port ]
ras-on
and "Configuring VoIP Entity" on page
H.323 Gateway Configuration
Remarks
-
-
Optional
The default is Wqldg0Hcwfydz.
If you want to change the
descriptor, do that under the
guidance of a technical
engineer.
-
Optional
No area ID is assigned by
default.
Required
No source IP address is bound by
default.
Required
No gateway alias is configured
by default. Each gateway can be
assigned only one alias.
Required
Not configured by default.
The default RAS port is 1719.
Optional
Not configured by default.
The default RAS port is 1719.
Required
Not activated by default.
"Configuring POTS
2271.
2361