Outputting Log Information To The Console - 3Com MSR 50 Series Configuration Manual

2152 C 119: I
HAPTER NFORMATION
n
Outputting Log
Information to the
Console
c
C C
ENTER ONFIGURATION
Step three: after the log file information has been created and the /etc/syslog.conf
file has been modified, issue the following commands to display the process ID of
syslogd, terminate a syslogd process, and to restart syslogd using the r option.
# ps -ae | grep syslogd
147
# kill -9 147
# syslogd -r &
Ensure that the syslogd process is started with the r option on a Linux log host.
After the above configurations, the system will be able to keep log information in
the related file.
Network requirements
Log information with a severity higher than informational will be output to the
■
console;
The source module is ARP.
■
Network diagram
Figure 635 Network diagram for sending log information to the console
Console
PC
Configuration procedure
# Enable information center.
<Sysname> system-view
[Sysname] info-center enable
# Specify the channel to output log information to the console (optional, Console
by default).
[Sysname] info-center console channel console
# Disable the output of log, trap, and debug information of all modules to the log
host.
[Sysname] info-center source default channel console debug state off
log state off trap state off
CAUTION:
As the default system configurations for different channels vary, ensure that
■
the output of log, trap, and debug information for the specified channel
(console in this example) of all modules is disabled before the system
information can be output to meet the current network requirements.
Use the display channel command to display the state of a channel.
■
# Enable system information output for the ARP module, with information severity
ranging from emergencies to informational.
Device