3Com MSR 50 Series Configuration Manual page 1644

1644 C 85: Q S P
HAPTER O
n
C
OLICY ONFIGURATION
To do...
Configure to use traffic policing
Configure traffic filter action
Configure traffic shaping action
Configure traffic redirection action redirect { cpu | interface
Remark CLP value for an ATM cell remark atm-clp atm-clp-value
Configure DSCP value for the
remarked packet
Configure 802.1p priority for the
remarked packet
Remark DE value for FR packet
Configure IP priority value for the
remarked packet
Configure MPLS priority for the
remarked packet
Remark qos-local-id value for the
remarked packet
Display traffic behavior
information
Traffic shaping for software forwarding does not support IPv6.
Configuration example
1 Network requirements
Configure a traffic behavior test_behavior and use traffic policing. The CAR of
the traffic is 100 kbps.
2 Configuration procedure
# Enter system view.
<Sysname> system-view
# Define a traffic behavior and enter traffic behavior view.
[Sysname] traffic behavior test_behavior
# Configure the traffic behavior.
[Sysname-behavior-test_behavior] car cir 100
Use the command...
car cir
committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ] [ green
action ] [ red action ]
filter { deny | permit }
gts cir
committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size [ queue-length
queue-length ] ] ]
interface-type interface-number }
remark dscp dscp-value
remark dot1p 8021p
remark fr-de fr-de-value
remark ip-precedence
ip-precedence-value
remark mpls-exp mpls-exp
remark qos-local-id
local-id-value
display traffic behavior
{ system-defined |
user-defined } [ behavior-name ]
Remarks
Required
Users configure
corresponding traffic
behaviors as needed.
Optional
The display
command can be
executed in any view.