3Com MSR 50 Series Configuration Manual page 1584

1584 C 80: DVPN C
HAPTER ONFIGURATION
[Hub1] ike peer vam
[Hub1-ike-peer-vam] pre-shared-key abcde
[Hub1-ike-peer-vam] quit
# Configure the IPSec profile.
[Hub1] ipsec profile vamp
[Hub1-ipsec-profile-vamp] proposal vam
[Hub1-ipsec-profile-vamp] ike-peer vam
[Hub1-ipsec-profile-vamp] sa duration time-based 600
[Hub1-ipsec-profile-vamp] pfs dh-group2
Configure the DVPN tunnel
■
# Configure tunnel interface Tunnel 1 for VPN 1.
[Hub1] interface tunnel 1
[Hub1-Tunnel1] tunnel-protocol dvpn udp
[Hub1-Tunnel1] vam client dvpn1hub1
[Hub1-Tunnel1] ip address 10.0.1.1 255.255.255.0
[Hub1-Tunnel1] source ethernet 1/0
[Hub1-Tunnel1] ospf network-type p2mp
[Hub1-Tunnel1] ipsec profile vamp
[Hub1-Tunnel1] quit
Configure OSPF
■
# Configure OSPF for the public network.
[Hub1] ospf 100
[Hub1-ospf-100] area 0
[Hub1-ospf-100-area-0.0.0.0] network 192.168.1.1 0.0.0.255
[Hub1-ospf-100-area-0.0.0.0] quit
# Configure OSPF for the private network.
[Hub1] ospf 200
[Hub1-ospf-200] area 0
[Hub1-ospf-200-area-0.0.0.0] network 10.0.1.1 0.0.0.255
[Hub1-ospf-200-area-0.0.0.0] quit
4 Configure Hub 2
Configure the IP addresses of the interfaces (Omitted)
■
Configure the VAM client
■
<Hub2> system-view
# Create a VAM client named dvpn1hub2 for VPN 1.
[Hub2] vam client name dvpn1hub2
[Hub2-vam-client-name-dvpn1hub2] vpn 1
# Specify the IP addresses of the VAM servers and set the pre-shared key.
[Hub2-vam-client-name-dvpn1hub2] server primary ip-address 192.168.1.22
[Hub2-vam-client-name-dvpn1hub2] server secondary ip-address 192.168.1.33
[Hub2-vam-client-name-dvpn1hub2] pre-shared-key simple 123
# Create a local user named dvpn1hub2, setting the password as dvpn1hub2.
[Hub2-vam-client-name-dvpn1hub2] user dvpn1hub2 password simple dvpn1hub2
[Hub2-vam-client-name-dvpn1hub2] client enable
[Hub2-vam-client-name-dvpn1hub2] quit
Configure the IPSec profile
■
# Configure the IPSec proposal.