Configuring Number Of Redial Attempts - 3Com MSR 50 Series Configuration Manual

2418 C 139: V
HAPTER OICE
n
Configuring Number of
Redial Attempts
RADIUS C
ONFIGURATION
Configuration procedure
Follow these steps to configure the number of digits in a card number and that in
a password:
To do...
Enter system view
Enter voice view
Enter dial program view
Enter access number view
Specify the two-stage dialing process
as the card number/password
process
Configure the number of digits in a
card number
Configure the number of digits in a
password
The card-digit and password-digit commands apply only to the card
■
number/password process. They are unavailable in the case of the caller
number process and caller number process with IVR.
If a user is required to press the dial terminator # after dialing a card number
■
but fails to do so, the system will prompt timeout and require the user to redial
the card number. This rule also applies to a password.
The redialtimes command applies only to the card number/password process and
the caller number process with IVR. This command is unavailable in the case of the
caller number process.
For the card number/password process, a user first dials an access number, then
selects a language option, next enters a prepaid card number and password, and
finally dials a called number. The user can retry in each step of this process. To
prevent any dial mistake from causing a failure of the entire dialing process, you
need to specify the maximum number of dial attempts to provide fault tolerance.
For the caller number process with IVR, the number of redial attempts refers to the
times a called number can be redialed, and if you have enabled the language
selection function, you should also specify the maximum number of language
selection attempts.
Configuration prerequisites
You have configured an access number.
Configuration procedure
Follow these steps to configure the number of redial attempts:
To do...
Enter system view
Enter voice view
Use the command...
system-view
voice-setup
dial-program
gw-access-number
access-number
process-config cardnumber
card-digit card-digit
password-digit password-digit
Use the command...
system-view
voice-setup
Remarks
-
-
-
-
Required
Required
12 by default.
Required
6 by default.
Remarks
-
-