Udp-Jitter Test Configuration Example - 3Com MSR 50 Series Configuration Manual

UDP-jitter Test
Configuration Example
Network diagram
Figure 601 Network diagram for the HTTP test
NQA client
10 .1.1.1/16
IP network
Device A
Configuration procedure
# Create an HTTP test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type http
[DeviceA-nqa-admin-test-http] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-http] operation get
[DeviceA-nqa-admin-test-http] url /index.htm
[DeviceA-nqa-admin-test-http] http-version v1.0
[DeviceA-nqa- admin-test-http] quit
# Enable the HTTP test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of an HTTP test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1
Min/Max/Average round trip time: 64/64/64
Square-Sum of round trip time: 4096
Last succeeded probe time: 2007-03-27 13:40:36.2
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Network requirements
Use the NQA UDP-jitter function to test the delay jitter of packet transmission
between the local port (Device A) and the specified destination port (Device B).
Network diagram
Figure 602 Network diagram for UDP-jitter test
NQA client
10 .1.1.1/16
IP network
Device A
NQA Configuration Examples
HTTP server
10 .2 .2.2/16
Device B
Receive response times: 1
NQA server
10 .2 .2.2/16
Device B
2033