3Com MSR 50 Series Configuration Manual page 1932

1932 C 102: SSH2.0 C
HAPTER ONFIGURATION
[Router] user-interface vty 0 4
[Router-ui-vty0-4] authentication-mode scheme
# Enable the user interfaces to support SSH.
[Router-ui-vty0-4] protocol inbound ssh
[Router-ui-vty0-4] quit
#Create a local user named client001, and set the user command privilege level to
3.
[Router] local-user client001
[Router-luser-client001] password simple aabbcc
[Router-luser-client001] service-type ssh level 3
[Router-luser-client001] quit
#Specify the service type of user client001 as Stelnet, and the authentication
method as password.
[Router] ssh user client001 service-type stelnet authentication-type password
2 Configure the SSH client
n
There are a variety of SSH client software, such as PuTTY, OpenSSH, and so on.
The following is an example of configuring SSH client using PuTT v0.58.
# Establish a connection with the SSH server.
Launch PuTTY.exe to enter the following interface. In the Host Name (or IP
address) text box, enter the IP address of the server.