3Com MSR 50 Series Configuration Manual page 1996

1996 C 107: VRRP C
HAPTER ONFIGURATION
Network diagram
Figure 592 Network diagram for single VRRP standby group configuration
Gateway:
FE80::10
Host A
Configuration procedure
1 Configure Router A
<RouterA> system-view
[RouterA] ipv6
[RouterA] interface ethernet 1/0
[RouterA-Ethernet1/0] ipv6 address fe80::1 link-local
[RouterA-Ethernet1/0] ipv6 address 1::1 64
# Create a standby group 1 and set its virtual IPv6 address to FE80::10.
[RouterA-Ethernet1/0] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
# Configure the priority of Router A in standby group 1 to 110.
[RouterA-Ethernet1/0] vrrp ipv6 vrid 1 priority 110
# Set Router A to work in preemption mode.
[RouterA-Ethernet1/0] vrrp ipv6 vrid 1 preempt-mode
# Enable Router A to send RA messages.
[RouterA-Ethernet1/0] undo ipv6 nd ra halt
2 Configure Router B
<RouterB> system-view
[RouterB] ipv6
[RouterB] interface ethernet 1/0
[RouterB-Ethernet1/0] ipv6 address fe80::2 link-local
[RouterB-Ethernet1/0] ipv6 address 1::2 64
# Create a standby group 1 and set its virtual IPv6 address to FE80::10.
[RouterB-Ethernet1/0] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
# Enable Router A to send RA messages.
Virtual IPv6 address:
FE80::10
Eth1 /0
FE80::1
Router A
Internet
Eth1/0
FE80 ::2
Router B
Host B