Configuring Ipx Rip Parameters; Configuring Ipx Sap; Configuration Prerequisite; Enabling Ipx Sap - 3Com MSR 50 Series Configuration Manual

Configuring IPX RIP
Parameters

Configuring IPX SAP

Configuration
Prerequisite

Enabling IPX SAP

n
Routing protocols can redistribute routes from one another to share routing
information. However, a RIP router can only redistribute active static routes rather
than inactive static routes and advertise them to directly connected networks.
Follow these steps to configure IPX RIP related parameters:
To do...
Enter system view
Specify an IPX RIP update
interval
Configure an aging interval
for IPX RIP routing entries
Enter interface view
Configure the maximum
length of IPX RIP updates
n
The IPX RIP update interval must be identical on all routers in the network to
■
keep consistency of routing tables.
If a route entry is not updated within the aging interval, it will be removed from
■
the routing table and the associated dynamic service information entry is also
removed.
With IPX enabled on an interface, the system will automatically use SAP to
maintain and advertise dynamic service information. You can also configure the
SAP related parameters or service information based on actual network
requirements.
Configuring IPX SAP updating feature;
■
Configuring GNS response of IPX SAP
■
Configuring IPX service information
■
You need configure IPX basic functions before this task.
Follow these steps to enable IPX SAP:
To do...
Enter system view
Enter interface view
Enable IPX SAP
Use the command...
system-view
ipx rip timer update
seconds
ipx rip multiplier multiplier
interface interface-type
interface-number
ipx rip mtu bytes
Use the command...
system-view
interface interface-type
interface-number
undo ipx sap disable
Configuring IPX SAP
Remark
-
Optional
The default is 60 seconds
Optional
The default is 3 times the
update interval
-
Optional
The default is 432 bytes.
Remark
-
-
Optional
By default, IPX SAP is enabled after IPX
is enabled on the interface.
2221