Configuring Options
Related to Dial Plan
Configuring Voice
Performance
Configuration
Prerequisites
Configuration Procedure
To do...
Enter system view
Enter voice view
Enter voice dial program view dial-program
Create a VoIP entity and enter
VoIP entity view
Enable VAD
Follow these steps to configure options related to dial plan:
To do...
Enter system view
Enter voice view
Enter voice dial program view dial-program
Create a VoIP entity and enter
VoIP entity view
Configure calling numbers
permitted to originate calls to
the local voice entity
Configure the priority of the
VoIP entity
Configure a dial prefix
Configure the called number
sending mode
For details about the above commands, refer to
page
2289.
You have completed the required configurations for VoIP entity.
Follow these steps to configure voice performance:
Configuring Voice Performance
Use the command...
system-view
voice-setup
entity entity-number voip
vad-on
Use the command...
system-view
voice-setup
entity entity-number voip
caller-permit calling-string
priority priority-order
dial-prefix string
send-number { digit-number
| all | truncate }
"Dial Plan Configuration" on
2275
Remarks
-
-
-
-
Optional
Disabled by default.
Note that G.711 codec does
not support VAD.
Remarks
-
-
-
-
Optional
By default, no calling number
is configured, that is,
incoming calls are not
restricted.
Optional
0 by default. The smaller the
value is, the higher the priority
is.
Optional
By default, no dial prefix is
configured.
Optional
By default, the truncate
mode is configured, that is,
numbers matching the
wildcard "." at the end will be
sent.