Frame Relay Fragmentation Configuration Example - 3Com MSR 50 Series Configuration Manual

1724 C 91: F
HAPTER RAME
Frame Relay
Fragmentation
Configuration Example
R Q S C
ELAY O ONFIGURATION
# Create Frame Relay PVC and associate the Frame Relay class with the PVC.
[Router-Serial2/0] fr dlci 16
[Router-fr-dlci-Serial2/0-16] fr-class 96k
Network requirement
Router A and Router B are connected via the frame relay network, and FR
fragmentation function (FRF.12) is enabled.
Network diagram
Figure 496 Network diagram of FRF.12
S 2/0
Router A
Configuration procedure
1 Configuration on Router A
# Configure the Frame Relay class test1.
<RouterA> system-view
[RouterA] fr class test1
[RouterA-fr-class-test1] cir allow 64000
[RouterA-fr-class-test1] cbs 64000
[RouterA-fr-class-test1] cir 64000
[RouterA-fr-class-test1] fragment 80
[RouterA-fr-class-test1] quit
# Configure the interface Serial 2/0.
[RouterA] interface serial 2/0
[RouterA-Serial2/0] link-protocol fr
[RouterA-Serial2/0] ip address 10.1.1.2 255.0.0.0
[RouterA-Serial2/0] fr traffic-shaping
# Create DLCI 16.
[RouterA-Serial2/0] fr dlci 16
# Apply the Frame Relay class named test1 to DLCI 16.
[RouterA-fr-dlci-Serial1/0-16] fr-class test1
2 Configuration on Router B
# Configure the Frame Relay class test1.
<RouterB> system-view
[RouterB] fr class test1
[RouterB-fr-class-test1] fragment 80
[RouterB-fr-class-test1] quit
# Configure the interface Serial 2/0 and enable Frame Relay traffic shaping.
Frame-Relay
network
S2/0
Router B