Configuring Call Transfer; Configuration Prerequisites; Configuring Call Transfer Using Command Lines; Configuration Example - 3Com MSR 50 Series Configuration Manual

Configuring Call
Transfer
Configuration
Prerequisites

Configuring Call Transfer

Using Command Lines

Configuration Example

Configuring Hunt
Group
Configuration
Prerequisites
[Sysname-voice-line2/0] call-forwarding unavailable enable forward-n
umber 3000
The router is equipped with an FXS voice interface card.
■
The call hold feature is enabled for the voice subscriber line of the call transfer
■
originator.
Call transfer is dependent of call hold. Therefore, you must enable call hold before
call transfer.
Follow these steps to enable call transfer and configure the call transfer start
delay:
To do...
Enter system view
Enter voice view
Enter voice subscriber line
view
Enable call transfer
Configure a call transfer
start delay
Telephone A calls Telephone B to establish a conversation, then performs a
hookflash to put Telephone B on hold. Telephone A calls Telephone C, and then
hangs up. Now the conversation between Telephone B and Telephone C is
established, and the call transfer by Telephone A is completed.
# Enable call transfer for the voice subscriber line of Telephone A.
<Sysname>system-view
[Sysname]voice-setup
[Sysname-voice]subscriber-line 2/0
[Sysname-voice-line2/0] call-transfer enable
The router is equipped with an FXS voice interface card.
Use the command...
system-view
voice-setup
subscriber-line
line-number
call-transfer enable
call-transfer
start-delay number
Configuring Call Transfer
Remarks
-
-
-
Required
Disabled by default.
This command applies only to the
originator gateway. For the recipient
and final recipient gateways, the
corresponding functions are enabled.
Optional
3 seconds by default.
2433