3Com MSR 50 Series Configuration Manual page 1511

[PE1] display ip vpn-instance
Total VPN-Instances configured : 1
VPN-Instance Name
vpn1
[PE1] ping -vpn-instance vpn1 10.1.1.1
PING 10.1.1.1: 56
Reply from 10.1.1.1: bytes=56 Sequence=1 ttl=255 time=27 ms
Reply from 10.1.1.1: bytes=56 Sequence=2 ttl=255 time=33 ms
Reply from 10.1.1.1: bytes=56 Sequence=3 ttl=255 time=7 ms
Reply from 10.1.1.1: bytes=56 Sequence=4 ttl=255 time=29 ms
Reply from 10.1.1.1: bytes=56 Sequence=5 ttl=255 time=9 ms
--- 10.1.1.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 7/21/33 ms
4 Establish EBGP peer relationship between PEs and CEs to allow VPN routes to be
injected
# Configure CE 1.
[CE1] bgp 65410
[CE1-bgp] peer 10.1.1.2 as-number 100
[CE1-bgp] import-route direct
[CE1-bgp] quit
# Configure PE 1.
[PE1] bgp 100
[PE1-bgp] ipv4-family vpn-instance vpn1
[PE1-bgp-vpn1] peer 10.1.1.1 as-number 65410
[PE1-bgp-vpn1] peer 10.1.1.1 next-hop-local
[PE1-bgp-vpn1] import-route direct
[PE1-bgp-vpn1] quit
[PE1-bgp] quit
n
The configurations for CE 2 are similar to those for CE 1 and the configurations for
PE 2 are similar to those for PE 1. The detailed configuration steps are omitted.
After completing the above configuration, if you issue the display bgp vpnv4
vpn-instance peer command on the PEs, you should see that BGP peer
relationship has been established between PE and CE, and has reached the state
of Established.
The following takes PE 1 as an example:
[PE1] display bgp vpnv4 vpn-instance vpn1 peer
BGP local router ID : 1.1.1.9
Local AS number : 100
Total number of peers : 1
Peer V
10.1.1.1 4 65410
5 Configure MP-IBGP peers between PEs
# Configure PE 1.
RD
100:1
data bytes, press CTRL_C to break
AS MsgRcvd MsgSent
5 5
MPLS L3VPN Configuration Example
Create Time
2006/08/13 09:32:45
Peers in established state : 1
OutQ PrefRcv Up/Down
0 1 00:02:03 Established
1511
State