3Com MSR 50 Series Configuration Manual page 1636

1636 C 84: T
HAPTER RAFFIC
C , P ,
LASSIFICATION OLICING AND
To do...
Enter interface Enter interface
view or port view
group view
Enter port
group view
Configure traffic shaping on
the interface
Display the GTS information
on each interface
Configuring traffic shaping applicable to all traffics
Follow these steps to configure traffic shaping applicable to all traffics
To do...
Enter system view
Enter interface Enter interface
view or port view
group view
Enter port
group view
Configure traffic shaping on
the interface
S
HAPING
Use the command...
interface interface-type
interface-number
port-group aggregation
agg-id
qos gts acl acl-number cir
committed-information-rate
[ cbs committed-burst-size
[ ebs excess-burst-size ]
[ queue-length
queue-length ] ]
display qos gts interface
[ interface-type
interface-number ]
Use the command...
system-view
interface interface-type
interface-number
port-group aggregation
agg-id
qos gts any cir
committed-information-rate
[ cbs committed-burst-size
[ ebs excess-burst-size ]
[ queue-length
queue-length ] ]
Remarks
Use either command
Configured in interface view,
the setting is effective only on
the current interface;
configured in port group
view, the setting is effective
on all the ports in the current
port group.
For the information about
port group configuration,
refer to "Link Aggregation
Configuration" on page 351.
Required
cbs is half of cir within unit
time by default. If the default
value is lower than 1875,
then 1875 is taken as the
default value.
ebs is 0 by default.
queue-length is 50 by
default.
Optional
The display command can be
executed in any view
Remarks
-
Use either command
Configured in interface view,
the setting is effective only on
the current interface;
configured in port group
view, the setting is effective
on all the ports in the current
port group.
For the information about
port group configuration,
refer to "Link Aggregation
Configuration" on page 351.
Required
cbs is half of cir within unit
time by default. If the default
value is lower than 1875,
then 1875 is taken as the
default value.
ebs is 0 by default.
queue-length is 50 by
default.