Configuring The Udp-Jitter Test - 3Com MSR 50 Series Configuration Manual

Configuring the HTTP test
Follow these steps to configure the HTTP test:
To do...
Enter system view
Enter NQA test group view
Configure the test type as
HTTP and enter test type view
Configure the destination
address for a test operation
Configure the source IP
address of a probe request
Configure the operation type
Configure the website that an
HTTP test visits
Configure the HTTP version
used in the HTTP test
Configure common optional
parameters
n
The TCP port number for the HTTP server must be 80 in an HTTP test. Otherwise,
the test will fail.
Configuring the
UDP-jitter Test
n
You are not recommended to perform an NQA UDP-jitter test on ports from 1 to
1023 (known ports). Otherwise, the NQA test will fail or the corresponding
services of this port will be unavailable.
Delay jitter refers to the difference between the interval of receiving two packets
consecutively and the interval of sending these two packets. The procedure of a
UDP-jitter test is as follows:
Configuring an NQA Test Group
Use the command...
system-view
nqa entry admin-name
operation-tag
type http
destination ip ip-address
source ip ip-address
operation { get | post }
url url
http-version v1.0
Refer to "Configuring
Optional Parameters Common
to an NQA Test Group" on
page 2028
2021
Remarks
-
-
Required
Required
By default, no destination IP
address is configured for a
test operation.
The destination IP address for
a test operation is the IP
address of the HTTP server.
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Optional
By default, the operation type
for the HTTP is get, that is,
obtaining data from the HTTP
server.
Required
Required
By default, HTTP 1.0 is used in
an HTTP test.
Optional