Configuring The Ftp Client - 3Com MSR 50 Series Configuration Manual

n
Configuring the FTP
Client
To do...
Log onto the remote FTP
server directly in user view
Log onto the remote FTP
server indirectly in FTP client
view
If no primary IP address is configured on the source interface, the FTP
■
connection fails.
If you use the ftp client source command to first configure the source
■
interface and then the source IP address of the transmitted packets, the new
source IP address will overwrite the current one, and vice versa.
Follow these steps to establish an FTP connection (In IPv6 networking):
To do...
Log onto the remote FTP
server directly in user view
Log onto the remote FTP
server indirectly in FTP client
view
After a device serving as the FTP client has established a connection with the FTP
server (For establishing FTP connection, refer to
on page 2106.), the device can perform the following operations for the
authorized directory:
To do...
Display help information of
FTP-related commands supported by
the remote FTP server
Enable information display in a
detailed manner
Enable FTP client debugging
Use other username to relog after
logging onto the FTP server
successfully
Set the file transfer mode to ASCII
Set the file transfer mode to binary
Use the command...
ftp [ server-address
[ service-port ] [ source
{ interface interface-type
interface-number | ip
source-ip-address } ] ]
ftp
open server-address
[ service-port ]
Use the command...
ftp ipv6 [ server-address
[ service-port ] [ source ipv6
source-ipv6-address ] [ -i
interface-type
interface-number ] ]
ftp ipv6
open ipv6 server-address
[ service-port ] [ -i
interface-type
interface-number ]
"Establishing an FTP Connection"
Use the command...
remotehelp
[ protocol-command ]
verbose
debugging
user username
[ password ]
ascii
binary

Configuring the FTP Client

Remarks
Use either approach.
Available in user view
Remarks
Use either command
Available in user view
Remarks
Optional
Optional
Enabled by default
Optional
Disabled by default
Optional
Optional
ASCII by default
Optional
ASCII by default
2107