Configuring Rule For Saving Cdrs - 3Com MSR 50 Series Configuration Manual

n
Configuring Rule for
Saving CDRs
Configuration prerequisites
A voice interface card (for example, an FXS interface card) is inserted in the router.
The authentication function is enabled for one-stage dialing users. Authentication
is a prerequisite for authorization. The authentication function must be enabled
before the authorization function. If the authentication function is not enabled for
one-stage dialing users, the authorization-did command is unavailable. If the
authentication function is disabled, the authorization function will automatically
be disabled.
Configuration procedure
Follow these steps to enable the authorization function for one-stage dialing
users:
To do...
Enter system view
Enter voice view
Enter voice AAA client view
Enable the authorization
function for one-stage dialing
users
Consecutive authorizations except the first one performed within the
authentication time limit will fail if the number of online users is limited to one for
an account in a CAMS serving as the RADIUS server. This rule applies to one-stage
dialing users and two-stage dialing users.
Each time a call is terminated, a CDR will be generated in the following two cases,
no matter whether the call is connected:
Any of the authentication, authorization, and accounting functions is enabled
■
for calls originated from the local voice gateway.
The accounting function is enabled for incoming calls of the local voice
■
gateway.
In view of the limited memory of the voice gateway, only limited number of CDRs
can be saved. Therefore, you can set a limit on saved CDRs. There are two ways to
limit CDRs saved in the voice gateway: One is to limit the number of CDRs and the
other is to limit the lifetime of CDRs. You can also set a CDR alarm threshold.
Configuration prerequisites
A voice interface card (for example, an FXS interface card) is inserted in the router.
Configuration procedure
Follow these steps to configure a rule for saving CDRs:
To do...
Enter system view
Enter voice view
Enter voice AAA client
view
Use the command...
system-view
voice-setup
aaa-client
authorization-did
Use the command...
system-view
voice-setup
aaa-client
Configuring Voice RADIUS
Remarks
-
-
-
Required
Disabled by default.
Remarks
-
-
-
2413