System Maintaining And Debugging - 3Com MSR 50 Series Configuration Manual

3com msr 30-16: software guide

Hide thumbs Also See for MSR 50 Series:

Safety information manual (12 pages)

Table of Contents

System Maintaining

and Debugging

System Maintaining

Figure 632 The relationship between the protocol and screen debugging switch

Screed output

Outputting debugging information to a terminal is most commonly used. You can

also configure to output debugging information to other directions, refer to

"Information Center Configuration" on page

Check whether a

specified IP

address can be

View the routes

from the source to

the destination

For a low-speed network, you are recommended to set a larger value for the

timeout timer (indicated by the -t parameter in the command) when

configuring the ping command.

Only the directly connected segment address can be pinged if the outgoing

interface is specified with the -i argument.

Screed output

Use the command...

ping [ ip ] [ -a source-ip | -c count | -f | -h ttl

| -i interface-type interface-number | -m

interval | -n | -p pad | -q | -r | -s packet-size |

-t timeout | -tos tos | -v | -vpn-instance

vpn-instance-name ] * remote-system

ping ipv6 [ -a source-ipv6 | -c count | -m

interval | -s packet-size | -t timeout ] *

remote-system [ -i interface-type

interface-number ]

tracert [ -a source-ip | -f first-ttl | -m max-ttl

| -p port | -q packet-number | -vpn-instance

vpn-instance-name | -w timeout ] *

remote-system

tracert ipv6 [ -f first-ttl | -m max-ttl | -p port

| -q packet-number | -w timeout ] *

remote-system