3Com MSR 50 Series Configuration Manual page 1999

[RouterA-Ethernet1/0] vrrp ipv6 vrid 1 priority 110
# Set the authentication mode of standby group 1 to SIMPLE and authentication
key to hello.
[RouterA-Ethernet1/0] vrrp ipv6 vrid 1 authentication-mode simple hello
# Set the interval for Router A to send VRRP advertisements to 500 centiseconds.
[RouterA-Ethernet1/0] vrrp ipv6 vrid 1 timer advertise 500
# Set Router A to work in preemption mode. The preemption delay is five seconds.
[RouterA-Ethernet1/0] vrrp ipv6 vrid 1 preempt-mode timer delay 5
# Set the interface to be tracked.
[RouterA-Ethernet1/0] vrrp ipv6 vrid 1 track interface ethernet 1/1 reduced 30
2 Configure Router B
<RouterB> system-view
[RouterB] ipv6
[RouterB] interface ethernet 1/0
[RouterB-Ethernet1/0] ipv6 address fe80::2 link-local
[RouterB-Ethernet1/0] ipv6 address 1::2 64
# Create a standby group 1 and set its virtual IP address to fe80::10.
[RouterB-Ethernet1/0] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
# Set the authentication mode of standby group 1 to SIMPLE and authentication
key to hello.
[RouterB-Ethernet1/0] vrrp ipv6 vrid 1 authentication-mode simple hello
# Set the interval for Router B to send VRRP advertisements to 500 centiseconds.
[RouterB-Ethernet1/0] vrrp ipv6 vrid 1 timer advertise 500
# Set Router B to work in preemption mode. The preemption delay is five seconds.
[RouterB-Ethernet1/0] vrrp ipv6 vrid 1 preempt-mode timer delay 5
3 Verify the configuration
After the configuration, Host B can be pinged through on Host A. You can use the
display vrrp ipv6 command to verify the configuration.
# Display detailed information of standby group 1 on Router A.
[RouterA-Ethernet1/0] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
IPv6-Based VRRP Configuration Example
: VIRTUAL-MAC
: Ethernet1/0
: 1
: UP
: 110
Adver. Timer : 500
State : Master
Run Pri : 110
1999