Netstream Configuration Task List; Configuring Netstream Statistics; Configuration Prerequisites; Configuring Netstream Aggregation Statistics - 3Com MSR 50 Series Configuration Manual

NetStream
Configuration Task
List
Configuring
NetStream Statistics
Configuration
Prerequisites
Configuring NetStream
Statistics
Configuring
NetStream
Aggregation Statistics
Configuration
Prerequisites
Configuring NetStream
Aggregation Statistics
Configuration tasks
"Configuring NetStream Statistics" on page 2041
"Configuring NetStream Aggregation Statistics" on page 2041
"Configuring Attributes of NetStream UDP Packets" on page 2042
"Configuring NetStream Statistics Aging" on page 2043
Before configuring this function, you must configure the NetStream interface
binding function.
To do...
Enter system view
Configure NetStream cache
size
Enter interface view
Enable NetStream statistics on
an interface
Before configuring this function, configure NetStream statistics first.
To do...
Enter system view
Enter a NetStream
aggregation view
Enable the specified
NetStream aggregation mode

NetStream Configuration Task List

Use the command...
system-view
ip netstream max-entry
max-entries
interface interface-type
interface-number
ip netstream { inbound |
outbound }
Use the command...
system-view
ip netstream aggregation
{ as | destination-prefix |
prefix | protocol-port |
source-prefix }
enable
2041
Remarks
Required
Optional
Required
Optional
Remarks
-
Optional
The value ranges from 1000
to 100000 and defaults to
10000.
-
Required
NetStream statistics is not
enabled on an interface by
default.
NetStream statistics can be
enabled on both the inbound
and outbound direction of an
interface.
Remarks
-
Required
Required
No aggregation mode is
enabled by default.