Configuring Dss1 And Q.sig Signaling - 3Com MSR 50 Series Configuration Manual

2330 C 134: E1
HAPTER AND
Configuring DSS1 and
Q.SIG Signaling
T1 C
ONFIGURATION
To do...
Configure register signal
values in R2 signaling
Configure the duration of
register pulse signals such as
A-3, A-4, and A-6 in R2
signaling
Configure the maximum time
waiting for a Group B signal
After you create a PRI set with the pri-set command on an E1/T1 interface, a serial
interface is automatically created. This interface is named serial number:15 on an
E1 interface and serial number:23 on a T1 interface. You may enter the view of
the interface with the interface serial number:{ 15 | 23 } command to configure
DSS1 and Q.SIG user signaling.
Configuration prerequisites
The router is equipped with a VE1/VT1 interface card that supports DSS1 and QSIG
signaling.
Configuration procedure
Follow these steps to configure DSS1 or Q.SIG signaling:
To do...
Enter system view
Enter E1/T1 interface view
Bundle timeslots into a PRI set pri-set [ timeslot-list range ] Required
Exit E1/T1 interface view
Use the command...
register-value
{ billingcategory |
callcreate-in-groupa |
callingcategory |
congestion |
demand-refused | digit-end
| nullnum |
req-billingcategory |
req-callednum-and-switchg
roupa | req-callingcategory
| req-
currentcallednum-in-group
c | req-currentdigit | req-
firstcallednum-in-groupc |
req-firstcallingnum |
req-firstdigit |
req-lastfirstdigit |
req-lastseconddigit |
req-lastthirddigit |
req-nextcallednum |
req-nextcallingnum |
req-switch-groupb |
subscriber-abnormal
|subscriber-busy |
subscriber-charge
|subscriber-idle } value
timer register-pulse
persistence time
timer register-complete
group-b time
Use the command...
system-view
controller { e1 | t1 } number
quit
Remarks
Optional
The defaults vary by country
mode.
Optional
150 milliseconds by default.
Optional
30,000 milliseconds by
default.
Remarks
-
-
-