Configuring A Dial Terminator; Configuring Voice Entity Selection Priority Rules; Configuration Prerequisites; Configuration Procedure - 3Com MSR 50 Series Configuration Manual

Configuring a Dial
Terminator
Configuring Voice
Entity Selection
Priority Rules
Configuration
Prerequisites

Configuration Procedure

To do...
Enter system view
Enter voice view
Enter voice dial program view dial-program
Configure a global number
match mode
In areas where variable-length numbers are used, you can specify a character as
the dial terminator so that the voice gateway can dial out the number before the
dialing interval expires. The dial terminator identifies the end of a dialing process,
and a call connection will be established based on the received digits when the
dial terminator is received: The system router will not wait for further digits even if
the longest match mode has been globally configured.
Follow these steps to configure a dial terminator:
To do...
Enter system view
Enter voice view
Enter voice dial program view dial-program
Configure a dial terminator
If multiple voice entities can match a call number, the voice gateway follows the
configured rules to select a proper voice entity to initiate a call. If no voice entity
type selection priority or voice entity selection priority rule is configured, the voice
gateway selects a voice entity at random to initiate a call.
The match sequence is as follows:
Voice entity type selection priority rule: This rule means that different priorities
■
are configured for different types of voice entities (VoIP, POTS and VoFR). The
voice gateway matches a voice entity according to the priorities of different
types of voice entities.
Voice entity selection priority rules: These rules cover exact match, priority,
■
random selection, and longest idle time. For details, refer to Dial Plan
Commands in Voice Volume. You can select one to three rules to form a
sequence. The voice gateway will first select a voice entity according to the first
rule. If the voice gateway fails to distinguish the priorities of voice entities
according to the first rule, it will apply the second rule, and so on.
The required basic configurations have been completed on POTS, VoIP, and VoFR
entities.
Follow these steps to configure voice entity selection priority rules:

Configuring Voice Entity Selection Priority Rules

Use the command...
system-view
voice-setup
number-match { longest |
shortest }
Use the command...
system-view
voice-setup
terminator character
2295
Remarks
-
-
-
Required
By default, the
shortest-number match mode
is adopted.
Remarks
-
-
-
Optional
By default, no dial terminator.