3Com MSR 50 Series Configuration Manual page 1640

1640 C 84: T
HAPTER RAFFIC
C , P ,
LASSIFICATION OLICING AND
Configuration procedure
1 Configure on Router A
# Configure GTS on the interface Ethernet1/0 of Router A to shape the traffic
transmitted from the interface (shaping the traffic exceeding 0. 5 Mbps) so as to
reduce the packet drop rate of the interface Ethernet1/1 of Router B.
<RouterA> system-view
[RouterA] interface ethernet1/0
[RouterA-Ethernet1/0] qos gts any cir 500
[RouterA-Ethernet1/0] quit
# Configure the ACL to match the packets from Server and Host A.
[RouterA] acl number 2001
[RouterA-acl-basic-2001] rule permit source 1. 1. 1. 1 0
[RouterA-acl-basic-2001] quit
[RouterA] acl number 2002
[RouterA-acl-basic-2002] rule permit source 1. 1. 1. 2 0
[RouterA-acl-basic-2002] quit
# Configure TP on the interface Ethernet1/1 to perform the corresponding traffic
control on the different traffics received by the interface Ethernet1/1.
[RouterA] interface Ethernet1/1
[RouterA-Ethernet1/1] qos car inbound acl 2001 cir 54 cbs 4000 ebs 0
green pass red remark-prec-pass 0
[RouterA-Ethernet1/1] qos car inbound acl 2002 cir 8 cbs 1875 ebs 0
green pass red discard
[RouterA-Ethernet1/1] qos car inbound any cir 500 cbs 32000 ebs 0 gr
een pass red discard
2 Configure Router B
# Configure TP on the interface Ethernet1/0 to perform traffic control on the
traffic transmitted on the interface Ethernet1/0. The traffic should not exceed 1
Mbps and the ultra-long packets will be dropped.
<RouterB> system-view
[RouterB] interface Ethernet1/0
[RouterB 2-Ethernet1/0] qos car outbound any cir 1000 cbs 65000 ebs
0 green pass red discard
S
HAPING